Image Image Image Image Image Image Image Image Image Image

EDIFY | November 25, 2017

Scroll to top

Top

6 3/4” Low Profile CFL

206 Features

1. Reflector: Hydroformed aluminum, .040” thick (18 ga.); matte white trim flange.

2. Slot Aperture: Die-formed aluminum, .040” thick (18 ga.). Aperture plate and inner shield, matte black inside, matte white finish outside. Cuts off glare at normal viewing angles.

3. Frame-In Kit: (2000LV standard frame shown.) Other frames shown on the right. See Frame-In Kit specification sheets for more details.

 

1102T Features

1. Mounting Frame: #20 ga. galvanized steel. Accommodates ceiling up to 1” thick. Push-in/twist-out rotoclips hold reflector flush to ceiling.

2. Junction Box: #14 ga. galvanized steel. Rated for 8 #12 AWM through branch circuit wires suitable for 90° C, for end of run 75° C. Quick release “L” shaped cover for access to wiring. Integral cable clamps permit attachment of non-metallic Romex® or armored cable without the need for separate connectors.

3. Mounting Bars: Die-formed steel, 16 ga. Four bars, 13” long, extend to 27”, permit off-center mounting; bars rotate 90° and lock in both directions; integral nailer for wood joists, locking tabs for T-bar runners.

4. Socket Housing: 22 ga. galvanized spring steel; snap-in quick assembly for precise lamp location.

5. Socket: Molded thermoplastic; prewired with #18 AWM leads to 4” X 3 1/2” X 2” junction box.
6. Thermally Protected Ballast: Single 2 lamp magnetic or universal voltage electronic, Class-P Rated. Insulation must be kept 3” away from fixture sides and wiring compartment and must not be placed above fixture as to entrap heat.

 

1113T Features:

1. Reflector: Hydroformed aluminum, 18 ga.; white gloss finish on inside and trim flange.

2. Cone: Hydroformed aluminum, specular finish.

3. Frame-In Kit: (1102T1 standard frame shown; other frames listed above.) See Frame-In Kit specification sheet for more details.

 

1126 Features

1. Reflector: Hydroformed aluminum, 18 ga.; white gloss finish on inside and trim flange.

2. Fresnel Lens: Clear acrylic lens. Provides high efficiency with brightness control, regressed to minimize brightness at normal viewing angles.

3. Splay: Injection molded opaque white Valox®.

4. Frame-In Kit: (1102T1 standard frame shown; other frames listed above.) See Frame-In Kit specification sheet for more details.

Lytecaster® Recessed Downlighting 2006

Reflector Trim

Frame-In Kit

Installation Type

Lamping

Height

2006
Matte White

2000LV

Stantdard Non-IC
Remodeler

20W-50W MR16

5 3/8"

2000LVR

Remodeler Non-IC

5 3/8"

2000LVRE1

Remodeler Non-IC

5 3/8"

2000LVE1

Electronic Low Voltage Non-IC 120V

5 3/8"

2000LVE2

Electronic Low Voltage Non-IC 277V

5 3/8"

2004ICV/N

Lytening AirSeal IC

20W-37W MR16

7 1/4"

2000LVNT

Low Voltage Remote Transformer

20W-42W MR16

5 3/8"

2000AICV

AirSeal IC

20W-35W MR16

7 5/16"